New Features

• Clear View Mode: Hide status bar and flight information on-screen

• RTSP Streaming: Stream video to third-party platforms like VLC using Livedeck II WiFi

Bug fixes and optimizations

• Optimized streaming performance

• Fixed other known issues.

Note

• Livedeck II is only compatible with EVO II V3.

• Only EVO II V3 firmware version V1.1.78 or above is compatible with Livedeck II V1.0..24.

Resource

• V3 Smart Controller Android System https://www.autelrobotics.com/download/576.html

• Autel Explorer App: https://www.autelrobotics.com/download/161

• EVO II V3 Firmware: https://www.autelrobotics.com/download/551.html

• EVO II V3 Firmware Version Table: https://www.autelrobotics.com/download/552.html

Manual Update Steps:

1. Turn on the Livedeck II firmware and wait a minute for the system to start up.

2. Download the Livedeck II firmware to a microSD card.

3. Insert the microSD card into the slot on the back of your Livedeck II firmware.

4. After a few seconds, the battery LED indicator light will begin flashing alternately, indicating that the update process has started. Allow the update to proceed for 10 minutes.

5. After 10 minutes, power cycle your Livedeck II and verify the firmware version.

Check Livedeck II Firmware Version ( Video Reference)

1. Power on both the V3 Smart Controller and the Livedeck II.

2. Connect the V3 Smart Controller and the Livedeck II using a USB-A to USB-C cable. (Connect USB-A to the Livedeck II and USB-C to the V3 Smart Controller).

3. Go to Settings > Connected devices > USB on the V3 Smart Controller.

4. Choose USB tethering for USE USB FOR section.

5. Open the Autel Explorer App on the V3 Smart Controller and wait for a few seconds. The Livedeck II settings page will appear automatically.

6. Once you see the Livedeck II settings page, navigate to About and then Firmware Version to view the Livedeck II firmware version.

Firmware Version Table

COMPONENT	LIVEDECK II V1.0.24
App	1.0.0.29
MCU	1.0.1.2
Image Transmissionr	1.1.1.49